Ickle, and shiny.

Discussion in 'UK Motorcycles' started by Muck, Nov 6, 2008.

  1. Muck

    Muck Guest

    Muck, Nov 6, 2008
    #1
    1. Advertisements

  2. Muck

    platypus Guest

    I've often thought that a scooter power pack would be a fine basis for that
    sort of mini-trike. The white alloy wheels don't work, though - should be
    spoked, with vintage-looking tyres.
     
    platypus, Nov 7, 2008
    #2
    1. Advertisements

  3. Muck

    Muck Guest

    Yes, a scooter power pack is ideal for this sort of thing. Not so sure
    about a rear alloy, and front spoked wheels though. I'd have thought
    alloys were lighter, which is the point of the builder using scooter
    front wheels[1] I'd have thought. They should be sprayed a moody black
    colour.

    Use a 125cc engine, and it would be learner legal? Use a 500cc engine,
    and it would be fun.

    [1] Even if one is running backwards.
     
    Muck, Nov 7, 2008
    #3
  4. I was thinking how good they look. Modern, and at least with clean
    lines and no stupidly complicated design.

    Put a set of Trials tyres on it ... ;)
     
    Paul - xxx mobile, Nov 7, 2008
    #4
  5. Muck

    Pete Fisher Guest

    A sort of modern take on a Lomax. If I hadn't gone for the MX5 was
    considering a Grinnal, but the rapid exit after an excursion up the bank
    of the one competing at Hartland in April cured me.
    --
    +----------------------------------------------------------------+
    | Pete Fisher at Home: |
    | Voxan Roadster Gilera Nordwest * 2 Yamaha WR250Z |
    | Gilera GFR * 2 Moto Morini 2C/375 Morini 350 "Forgotten Error" |
    +----------------------------------------------------------------+
     
    Pete Fisher, Nov 7, 2008
    #5
  6. Muck

    Nige Guest

    Why would you use bike rear tyres on the front of that? Unless you are
    leaning it there will be **** all grip?

    Nige
     
    Nige, Nov 7, 2008
    #6
  7. Muck

    Pete Fisher Guest

    Interesting point. Size matters.
    Whilst you can get 17 inch low profile car tyres they are very wide.
    They would probably make the steering too heavy.

    As platy said, spoked wheels would look better. Then you could go for 15
    inch rims and the kind of Firestone tyre I had on the back of my outfit.

    Having said that, the size of contact patch and grip might be better
    with the sports bike type tyres that have been used, than narrow car
    tyres.



    --
    +----------------------------------------------------------------+
    | Pete Fisher at Home: |
    | Voxan Roadster Gilera Nordwest * 2 Yamaha WR250Z |
    | Gilera GFR * 2 Moto Morini 2C/375 Morini 350 "Forgotten Error" |
    +----------------------------------------------------------------+
     
    Pete Fisher, Nov 7, 2008
    #7
  8. Muck

    Muck Guest

    I don't think those rims are 17", more like 13"
    Again.. very limited with a scooter engine, you just can't fit a 17" in
    there... so you'd end up with a 13" rim on the rear, and bigger spoked
    wheels on the front. It just wouldn't look right. Can you get 13" spoked
    wheels?
    Can you get car tyres to fit 13" scooter wheels?
     
    Muck, Nov 7, 2008
    #8
  9. Muck

    Pete Fisher Guest

    I suppose so, given the overall scale of the thing. What tyres are they
    do you reckon ?
    Hadn't thought about the limitation of the scooter swinging arm - good
    point. You can get small rims for junior MX bikes right down to 12 inch
    if you use suitable hubs. Built with heavy duty spokes they would be OK,
    but you are looking at probably less than 2 inch width. Classic sports
    cars might use them I suppose.

    What rim width are they?

    --
    +----------------------------------------------------------------+
    | Pete Fisher at Home: |
    | Voxan Roadster Gilera Nordwest * 2 Yamaha WR250Z |
    | Gilera GFR * 2 Moto Morini 2C/375 Morini 350 "Forgotten Error" |
    +----------------------------------------------------------------+
     
    Pete Fisher, Nov 7, 2008
    #9
  10. Muck

    Muck Guest

    Dunno, I'd put Michelin Pilot sports on there for grip though.
    Not really wide enough to put some decent tyres on imho. I think that
    using modern materials will give you more options. Spoked tyres are cool
    in an old world type way, but alloys is where it's at now. ;)
    Hmm.. they'll be about 3.5", so around a 130 section tyre?

    Scooter parts are cheap and plentiful, this includes brakes and other
    bits and bobs you'd need to build a complete car / trike / thing.
     
    Muck, Nov 7, 2008
    #10
  11. Muck

    fragmented Guest

    Spoked _tyres_? You must mean those little tiny moulding spiky bits,
    right? :)
     
    fragmented, Nov 8, 2008
    #11
  12. Muck

    Muck Guest

    Oh dear.. I mean the wheels.

    It's the drugs I tell yer. All of the hang over, none of the high.
     
    Muck, Nov 8, 2008
    #12
  13. Muck

    fragmented Guest

    You are definitely taking the wrong drugs!

    <goes off on another "high"> [1]





    [1] About as high as the mountains round MK - i.e. undulations.
     
    fragmented, Nov 9, 2008
    #13
  14. Muck

    Muck Guest

    Tell me about it. Not allowed caffeine or alcohol either.
     
    Muck, Nov 9, 2008
    #14
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.