Paging the metal fabricators.

Discussion in 'UK Motorcycles' started by Krusty, Oct 18, 2005.

Page 2 of 2
  1. Krusty

    Ginge Guest

    I just misread that as badger racing. Well, it'd be one way to get them
    to run.
     
    Ginge, Oct 19, 2005
    #21

    1. Advertisements

  2. Krusty

    Andy Bonwick Guest

    Stainless. It's easy to weld, easy to bend and reasonably good against
    attack. If you want to toughen it up a bit more then get it metal
    sprayed with a tungsten coating after manufacture. You can specify the
    thickness of tungsten deposit you want and it's not too expensive.
     
    Andy Bonwick, Oct 21, 2005
    #22

    1. Advertisements

  3. Krusty

    Krusty Guest

    Blimey, that all sounds a bit high-tec! I wonder...

    <fx: fires up eMachineShop>
     
    Krusty, Oct 22, 2005
    #23

    1. Advertisements

Page 2 of 2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. how to give striped metal a smooth finish?

  2. Oh for the good old days of metal side panels

  3. Top tip for fitting metal pins to rubber parts...

  4. Any T595/955i owners with metal fuel couplings - Help!

  5. bay area metal tank repair

  6. one for the heavy rock/metal fans

  7. Paging the bent-metal-isti

Loading...