Xmas comes early, it lives and TOG takes the biscuit.

I'll have to check, I think it's on rubber ones.

I'm not in a hurry, the bodywork is with Beav anyway so it can wait
after half term.

 

Thinking about it, IIRC you can fit earlier VHBs to the rubber intakes
just by removing the clamps and inserting them. The external diameter of
the bit that pushes in is the same on the 28mm PHBs I have.

OK, I may clean up the two 25mm spares I have anyway. They ought really
to go on Ebay as I can't see me using them again. The great de-clutter
in anticipation of moving house means I ought to sell off all the Morini
stuff that isn't required to rebuild the 2C/375 and keep it running.


--
+----------------------------------------------------------------+
| Pete Fisher at Home: |
| Voxan Roadster [ SPACE ! ] Yamaha WR250Z |
| Gilera GFR * 2 Moto Morini 2C/375 Morini 350 "Forgotten Error" |
+----------------------------------------------------------------+

 

took a blunt brush and painted...

I notice you tactfully avoiding answering what happens in any of my
suggestions...


<puts fingers in minds ear and goes to get petrol brush cutter out to
demolish hedge>

 

No, I got several in together, and lots of bits.

Checked all of them, new float needles as well.